IOM-421 BWC-1

TP-603 - SAFETY AND DE-ENERGIZATION PROCEDURES

GENERAL SAFETY

• Read and understand all instructions and warnings before using or servicing this equipment.
• Keep these instructions for future reference.
• Follow all federal, state and local requirements for handling and treatment of battery wash cabinet effluent.
• Battery Wash Cabinet (BWC) units are not designed to be shipped or transported after initial delivery.
• A licensed structural engineer should be consulted prior to installing a BWC on any building level other than the ground floor.
• Perform system and safety check before operating.
• Failure to follow these instructions and warnings may result in property damage, personal injury or death.

WORK AREA

• Keep work area clean and well lit. Cluttered work areas • and poor lighting can lead to accidents.
• Clean up/contain any fl uid spills immediately to pre-• vent slips or falls.
• Be aware of potential hazards when performing any • service or maintenance to the unit.

SERVICE & MAINTENANCE

Service personnel shall wear Personal Protective Equipment (PPE) appropriate for the task being performed.

LOCKOUT/TAGOUT

Lockout/tagout the BWC per your corporate policy, if damaged or not functioning properly. Lockout/tagout and deenergize all systems prior to performing any maintenance or service to unit.

LEAD-ACID BATTERIES-EXPLOSION HAZARD

Do not allow open fl ames or sparks of any kind near a battery. Highly explosive gas is generated when charging a battery that can remain in battery cells for extended periods of time after charging is complete.

• Always wear appropriate PPE including rubber apron, • gloves, boots and full face shield when performing service or maintenance to any lead-acid batteries.
• Do not place metal or other conductive objects on top • of battery. Arcing may occur causing damage to the battery and/or serious personal injury or death.

LEAD-ACID BATTERIES-EXPLOSION HAZARD (contd.)